Search Results for Query: *

PS replacment I have had great service from this company. PSC Motorsports. I have a psc box on my truck now, I ordered one with light valving and a fast ratio. great people to deal with. Just tell them what you ned.

I have 60,000 plus on the Walbro from GDP. At 15,000 on pump pressure was erratic . I thought it was the pump, turned out to be bad contacts on Dodge fuel pump relay, in PDS under hood. Installed my own relay and a toggle switch under hood to help with fuel filter changes. Dodge system only...

I hooked my hidden kill switch to the ground wire side of the fuel relay. Cut wire and ran to and back from switch. If I forget to turn the switch on , truck does not run and codes 1689 & 1693 . I your fuel relay has dirty contacts , these codes will show. Relay is cheap and the old one can be...

Eric, I had the 500 code for about 1 year, changed the speed sensor on the rear axle. No help. Speedometer always worked. I had same problem as you, while using cruise control. Sometimes while not using it. New APPS , no change. I lived with it, then read on TDR about bad grounds, used a drill...

The breather relocation kit from Cummins does work. The front cover Dodge spec breather is blocked using a 5/8" rubber cap, from NAPA. No oil leaks on steep hills forward or reverse . You can make your own set up as many members do. I ran a hose from the new valve cover mounted breather to the...

Cummins . . The new breather, Part number 3864201 and adapter, Part number 3976817, have reduced oil carryover on ISB 5. 9 engines. , using the Bosch VP44 fuel system,Install the new breather and adapter only after completing all other troubleshooting steps for oil carryover. Above is from...

NAPA 3270 is the same filter. Just changed mine thought that is was the problem. . low pressure, turns out I had a broken hose clamp on the intake of fuel pump. Sucking air , not good for power.

I went thru three factory lift pumps, got tired of dealer. purchased Glacier Diesel kit. Put 80,000 on it no problems- 19 psi idle and 14 full load. Had a problem ; yesterday pump pressure erratic , my low pressure alarm would come on then shut off with return of psi. Difficult to figure out ...

I had a problem like yours, turned out the ignition switch was at fault, Dealer back ordered. I could not wait and removed the plastic covering the ignition switch... used brake cleaner and sprayed dirt and grease out of switch. Truck works fine over last 80,000. Still have new switch as spare...

Take the floor mat out and anythingelse in the way of full clutch pedal travel. If clutch operates correctly ,leave mats out or cut and weld clutch pedal pivot pin or make the clutch master push rod shaft longer. Moved my pivot pin about 1/8 " clutch pedal is aprox. 1 " higher than brake pedal...

Pennzoil Synchromesh fluid works for me. It is recommended in NV 5600 trans. Mopar pn 4874464. More info www.pennzoil.com/penn/products/car_truck/gearoil.htlm One alternative to DC.

Put that NAPA UBP 360051 in. Followed you guys words of wisdom. Thank you ! Did put a piece of tape over the reservoir cap. This stopped the fluid from draining during the install. Pedal effort is nice, clutch engages right off the floor. Did have to remove the after market floor...

I am going to try the slave cylinder swap. NAPA online correct Part Number-- UBP 360051 $ 72. 00 UBP must be used with P/N