Search Results for Query: *

Sounds like your turbo is shot.

could you send the rev to me 512 749 0877 I am with verizon. thanks

Bobcat698 Heh Heh, I hear you. I used to drip outta the blowby tube, at least I thought I did, then when I went to address it, it turned out to be diesel from the return line that hooks up under the intake manifold against the engine. The line was rotten. Cheers

Thanks to the member who sent me the ring tone it's great. Cheers

My 1996 is bullet proof... . No oil leaks. 249505 miles on her.

Looks like way too much fun..... Any chance for me??? 512-749-0877 Cheers

Sounds like a good deal.

Pete I have averaged 15-16 mpg travelling at average speeds of 70-75 mph. This is start and stop and hwy. I also have a 4:10 ratio and one would think my mileage should be worse. Normally you would experience a slight power loss, (sluggish), and worse mileage with slipped timing. Other things to...

Timing could have slipped.

I may be wrong but this could be handed over to the feds as it is above $5000 and it crosses State lines. If not I feel like going fishing with concrete boots. Good luck.

Set your idle screw. 10mm wrench.

Check your load body for any loose bolts. I have heard them hum/you know what I mean.

I ground one like you mentioned and found that the motor ran smoother than my #10 she pulled good but it never had quite the aggression of the #10. I ended up using my # 10 again. Maybe when I get a better turbo I will try it again as I think she dumps a lot more fuel.

Depending on who runs the dyno, they can give values that include the drag coeficient (actual values at wheels), or engine values that do not include the drag calculation. Drag is the amount of power that is robbed from the engine to the wheels due to the drivetrain etc. I dyno bikes all the...

Here is what I found. When I blew my turbo I got a '99 turbo with bad wheels etc. I also liked the way the later models had the solenoid connected allowing me to discard the hard line on the earlier model. When I tried using the '99 turbine housing, it was smaller around the wheel area. I pulled...

Hi, A buddy of mine has a '99 and his a/c switches on and off and on and off... . repeatedly. Pressure is good and we have tried different relays with no change, we have also installed a new clutch switch located on the cannister, also with no change. There are no leaks. There was no warning, it...

Check this boards for sale items. There are a few good deals to get.

1996 as listed below 248000 and going strong.

No, it will not help. I ran a 16cm on mine and if you pull anything EGT'S will go way up. I went back to stock and opened the wastegate a bit by installing a 2000 model, which has a bigger wastegate than the '94 to '98 but requires a lot of grinding in the housing to accomodate the stock fan as...

Just put her in 5th and stand on the go pedal. If your clutch slips you will know right away. She should rev right up. It also all depends on how bad the clutch slips to determine if you can still get some good mileage outta her. After boming my truck I slipped real bad and bought a new valair...