2013 3500 4x4 6.7 SRW What Ball Joints?

[aerialimage]

2013 3500 4x4 needs ball joints again. Has about 130k on this set of factory joints.
I always liked Moog, What should I consider now?

 

[Topzide]

What about spending the coin on the rebuildable type like EMF that Genos sells? Think this will be the route that I'll go when that time comes as you can rebuild vs. replace. I liked the Mevotech front hubs that I put on the truck. They seem to be a pick of others on here over Moog. Your choice on what you'd like to install. Rockauto.com would be the place to compare prices and flavors.

 

[AEdelheit]

EMF, Dynatrak and Carli are the top 3, with how much labor is involved you will be money ahead to do it once and do it right.

 

[Ozymandias]

No MOOG for me, binding out of the box and didn't loose up using them for a couple thousand miles. Replaced with Carlis.

 

[06 Dodge]

The shop that replaced them on my old 2006 2500 4x4 used Moog HD greaseable ball joins, some 15K later when I sold it they were still going great and last I talked to new owner they did not report any problems in front end, only problem reported was AC gave out...

 

[TRAMPLINEMAN]

I put EMF’s in my ‘14 twoish years ago. I grease them every oil change and haven’t had any issues.