A long shot, but does anyone know this part #?

[DZink24]

Anyone know the P/N for the 2 little screws that hold the IAT sensor into the stock air box? I want to switch out the BHAF for the winter, and my dad does not remember where he put them when he "needed to use better screws" to secure it to my new piping. The ones he used are a bit too wide for the stock box. Really boneheaded Q, I know, but it is literally like looking for 2 needles in a haystack in that shop of his. TIA

 

[rbattelle]

Sorry, can't find it in the parts manual. If you want I can go measure one of mine tomorrow afternoon, then you can just buy new ones.



Ryan

 

[DZink24]

Thx for the info, I will most likely take the box to a parts store and see if they can match the correct width, hopefully they are not too uncommon of a size... I called dad, told him to rack his brain, see if he remembers...

 

[p-Bar]

Took mine out and measured, #6 pan head 3/4" long

 

[testraub]

This is why when screws come out for a project they go right into a ziploc bag and get marked for where they go. Not a lecture, just an idea for future projects.

 

[rbattelle]

This is why when screws come out for a project they go right into a ziploc bag and get marked for where they go. Not a lecture, just an idea for future projects.

Great advice. I save all my McMaster bags so I don't have to pay for ziplocks.



Ryan

 

[nickleinonen]

Great advice. I save all my McMaster bags so I don't have to pay for ziplocks.



Ryan

i don't order from them often [duty charges] but them little baggies they ship with are sure nice