2nd Gen Non-Engine/Transmission BD 2wd Low

[Flats]

Hi All,

Just installed BD 2wd Low kit. I think I will really like it for backing up the trailers. The install took about 3 hours. I installed the swicth in the cubby hole. but wented to see whare you all put yours? I can move the switch and not know the diffents. so I would like to hear ware you installed your swicth.

Thank

Glen

 

[SDrake]

Mine is mounted on the shifter lever. Kit I bought from member McKinsey. Be carefull not to over torque the drive train while operating in LOW. I have heard that the transfer case cannot take much over 1100 RPM. But I really like 2wheel lo. Backing on level ground is done smoothly at idle while controlling motion with the brake and no skipping and hopping. Very little throttle required to back up hill. But with four wheel engaged it would always take some extra throttle to work through the wheel dragging especially during turns.