Here I am

Competition BIT the big one...

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Competition Shade tree 1st Gen pulling Q.

Competition dyno day

ordered my silver bullet today from II, should be here end of next week. (hope it wasn't a mistake. . )



scot
 
0-plate, EDM'ed injectors 5x18, 3/4 tube pick up in tank to fass 150-gph @45psi, 8-an feed & return line.



scot
 
That's alot of fuel, or alot of potential depending on the pump... ... way more than I'm currently running! There are no spooling issues with a Bullet, it's much better than my old SPS 66... ... just did the change!



Jim
 
If the Injection pump is setup right then the Silver Bullet should suit you quite well.



I've run quite a few of them on my guys trucks. That turbine kicks rear big time.



~Wes~
 
If the Injection pump is setup right then the Silver Bullet should suit you quite well.



I've run quite a few of them on my guys trucks. That turbine kicks rear big time.



~Wes~





I like the bottom end much, much better but also did one of those long hard pulls yesterday to EGT level out and rotate speed, it was wierd seeing my truck go lean and mean. It's actually impressive with the Water/Meth on for the added timing.



Jim
 
Scot you will love that charger!!!!



EHarvey did 570 at the last fall brawll with 5X. 018's, High flow DV's, 4k GSK and a 150 FASS











Michael
 
Back
Top