2nd Gen Non-Engine/Transmission Can not match up brake switch ?

[JFaughn]

I had a problem with it when I bought it , on the way home the cruse would shut off & the Lock up would turn off , lifted the peddle , and every thing worked , so when I got home , I hot glued a small washer on to the foot of the sw. worked for the last 3 yrs , now the brake light was staying on , was not near my glue gun , but I was at a Napa store , so I bought a sw. , installed it at my next stop , then my cruse , lock up wouldn't work , and the brake lite & ABS came on , put in the old sw with a larger spacer , still had all the same problems , when I had them both in my hand at the same time , I saw that the foot of the new sw was about 1/2" longer , it would not go into the mount with out bending the mount for the longer foot/pushbutton , stop at the next Napa , and could not find a sw to match mine .
Now the bigger problem is it may have screwed up the computer [ no lockup , cruse & both brake lites on ] , need to find the right sw , and try to get Napa to cover the computer .
Has anyone els had a problem finding a brake lite sw for a 94 ?
And or the same problem with cc , lo up , brake lites ?
Thanks John

 

[Joe G.]

Do you have a Dodge service manual? There is a simple procedure for installing the switch and adjusting it that is not obvious from just looking at the switch. The end can be pulled out quite a ways so you may have the correct switch.

 

[JFaughn]

Thanks I'll check that out .

 

[fest3er]

Yup. I recently replaced mine. It wasn't obvious, but the rod does pull out and push in to adjust it to the right length. It was just a little exasperating until we figured it out.

N