Here I am

Guages....which order to install?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Backup warning sensor needed

trans Reverse light switch

Status
Not open for further replies.
HI All,



Just ordered 4 Isspro guages (EV series) and the 4 hole dash mount. I can't wait to get them and put them in my truck to get some baseline readings before I start Bombing..... Question is is there a preferred order for the guages to be in?



I'm thinking of installing them in this order (left to right)



Pyro , Trans temp , Boost , Tach.....



(I kinda figured that would be the order from most important to least inportant)..... Any other Ideas or reasons to set it up any other way?... . Any input would be greatly appreciated.



Thanks

Andrew
 
I watch my boost and pyro the most. I don't even bother with the trans. temp. unless I am towing. I've been thinking about adding more guages; oil psi, oil temp. , and fuel psi. Might even go with a rear axle temp. later down the road.



Nathan
 
Ive got mine from most active to least pyro, boost, fuel pressure, trans (trans is on the steering column and the other 3 are top down on a pillar pod)
 
Status
Not open for further replies.
Back
Top