Here I am

Help with EZ/engine problem

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

I THINK I found out about the lsd in my truck.

Durability of folding the trailer tow mirrors twice a day

Status
Not open for further replies.
Hooked up an EZ on a '01 Ram and took it for a ride and the "Malfunction Indicator Light" came on, and stayed on, and absolutely no power. Rechecked the connections and the stock engine wiring harness connector into the supplied MAP sensor connector was loose. Tightened this connector up and all kinds of power, but the malfunction indicator light stays on. Any suggestions on what to do next? Should I disconnect a battery and hook back up? Any help would be greatly appreciated.
 
disconnect the neg(-) cable for at least ten seconds to clear codes.

------------------
Todd,
2001 Q-cab SB 4x4 5spd 3. 55's, A pillar Boost/EGT,Jardines 4" turboback kit,custom built aluminum airbox W/K&N-RE0860 through the cowl, and more to come...
 
I agree with unhooking the battery. To check for problems, look at the connectors on the EZ and make sure there are no plastice on the metal terminals. I have seen some aftermarket boxes that have plastic "flash" on the metal terminals. It also helps if you use dielectric grease anytime you unplug any electrical connectors. This keeps corrosion to a minimum.

later
Don


------------------
Ol' Blue "First of the first gens: 1989 D 250 Ice blue met. 5 spd 3. 54, 155,000, Banks stage III powerpack, 3. 5" straight exhaust, pump adjustments, "'Ol Blue Special" injectors.
1999 3500 4x4 Chassis cab Emerald green ISB 5 spd 4. 10 K&N Filter straight exhaust 9 ft flatbed WARN fenderflares,Let, 275hp injectors installed, boost and pyro gages, VA plug'n power and Practical Solutions boost module. Jacobs E brake. Getting ready to install Banks Power Pack TLC!!
May buy another one in 2009!!
Check us out at:
http://donstractorrepair. homestead.com
 
to pull codes turn key on,off,on,off,and on count the flashes and pauses and flashes. post them here and someone can tell you what they are.

ex. on, pause, on,on,on,on=14=map sensor voltage too low/high
 
You guys are all genisus, did I spell that right? Anyway, the battery disconnect did the trick. I really appreciate you all coming on and helping this mechanically inept... . out.

Thanks again
Bill
 
genius, spelled B O O K W O R M. #ad


your welcome. #ad



------------------
Todd,
2001 Q-cab SB 4x4 5spd 3. 55's, A pillar Boost/EGT,Jardines 4" turboback kit,custom built aluminum airbox W/K&N-RE0860 through the cowl, and more to come...
 
Status
Not open for further replies.
Back
Top