Engine/Transmission (1998.5 - 2002) Hey Guys , Whats This Thing For ?

[Allnew2Me]

1 2

 

[Signal73]

I have 2 of them under there

 

[Huff N Puff]

Its the connector that would hook to the front wheel sensors if you had 4wheel antilock you probably have rearwheel antilock and therefore the connector isn't used. If I'm wrong I should get an atta boy,for coming up with some beliveable BS.

 

[BLACKRAM]

It powers my Mojo

 

[Diesel Nut]

I'm all in on the laser giuded missle option. Takes road rage to a new level!

 

[Nyoest]

Blinker fluid sensor, you get low it lets ya know

 

[Nate]

That would be cool to have some AIM-9Xs hanging off the sides of the truck. Not laser guided though. AGM-65 would be, over 500lbs though.

 

[DieselMinded]

well some how my 4x4 light now stays lit all the time ... WTH is going on here ?



DM

 

[AKAMAC]

DM, You don't have the CAD axle. It's for the position switch on vaccum motor on 01. 5 and earlier units. Mike

 

[Huff N Puff]

well some how my 4x4 light now stays lit all the time ... WTH is going on here ?



DM

The Light usually stays on cause, the actuator on the differential gets stuck,Its pretty simple to take apart and unjam it.

 

[DieselMinded]

AKAMAC ..... AttaBoy



H&P wheres the actuator located / Whats it look like ?



DM

 

[DieselMinded]

Any body know how to stop my 4wd light from being on all the time and to get it back working when in 4x4??



DM

 

[AKAMAC]

DM, look for a switch on the TC itself. Kinda like the reverse switch on a transmission.

Mike

 

[DieselMinded]

OK Sorry but the Attaboy will have to be taken back ... HEHEHE



The Connection is not for ... ... ... ...



muffler bearing sensor

Laser guided missle option

Plug in for jumpstarting Powerstrokes

plug is for the foglights x2

piston return spring sensor

it powers the chick-magnet

Outside temp prob

glow plug light for ford/cummins applications

it's The Guy Magnet

its what makes it a 2002 and not a 2001. 5

It powers my Mojo

4wheel antilock

Blinker fluid sensor

CAD axle





I finally decided to attack the flashing 4x4 light And couldnt find the connector ,



I approched this connector and was looking for the other end and found 2 wires laying behind the bumber I had my brother in the truck and when ever I touched the wires together the 4wd light would blink



,. ,,,, this was just the wires the male end of the connecter must of fell off and just left the wires with little clips on the end of them ,,, I just stuck the wires in the female connector shown in the first post and taped it up and its working great... if it ever messes up again I will cut the whole plug out and hard wire it.



Thanks guys



DM