Ok installed a mystery switch as per the TST instructions:
Here
with the addition of a LED and diode including the jumper in the PDC.
#ad
Well everytime I start my truck the check engine light comes on with codes
P0622 (G) Generator Field Not Switching
Properly
An open or shorted condition detected in the generator
field control circuit.
P1765 (M) Trans 12 Volt Supply Relay CTRL
Circuit
An open or shorted condition is detected in the
Transmission Relay control circuit. This relay supplies
power to the TCC
P1765 (M) Trans 12 Volt Supply Relay Ctrl
Circuit
Current state of solenoid output port is different than
expected (4-speed auto. trans. only).
I can clear the code but any time the ignition is on for more than 10 seconds it sets itself again. Just wondering if anyone else has run into the jumper causing this problem?
Here
with the addition of a LED and diode including the jumper in the PDC.

Well everytime I start my truck the check engine light comes on with codes
P0622 (G) Generator Field Not Switching
Properly
An open or shorted condition detected in the generator
field control circuit.
P1765 (M) Trans 12 Volt Supply Relay CTRL
Circuit
An open or shorted condition is detected in the
Transmission Relay control circuit. This relay supplies
power to the TCC
P1765 (M) Trans 12 Volt Supply Relay Ctrl
Circuit
Current state of solenoid output port is different than
expected (4-speed auto. trans. only).
I can clear the code but any time the ignition is on for more than 10 seconds it sets itself again. Just wondering if anyone else has run into the jumper causing this problem?