2nd Gen Non-Engine/Transmission Overhead display quit working

[AMikesell]

I just noticed that my overhead display is not working. I tried to figure out what is going on but nothing seemed to help, I replaced to unit with another one that I had that was good, checked the fuse and all of the connectors and still no luck. So has anyone has this happen and solved the problem? Any info is appreciated, thanks Andrew.

 

[PSpychalski]

According to the wiring diagram. the over head is fused twice. Once from the battery... the second thru the start/ignition switch. . check your other fuses. . best I can help you with... good luck

 

[PSpychalski]

Sorry... Should have mentioned there are also2 grounds. One splices into the other then thru a junction block to a common case ground. Let me know if this helps

 

[AMikesell]

Thanks for the info I found that it was the fuse from the battery that went bad, I replaced it and everything works great now. Once again thanks for the help, Andrew.