Here I am

2nd Gen Non-Engine/Transmission power window switch

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) Low Power After Start Up

2nd Gen Non-Engine/Transmission DSS/DT trac bar compatibility

Status
Not open for further replies.
hello, first off, this is my first post, so here goes, my drivers side window works like it should except the one touch down, is it the switch, relay, motor, any idea of where to start would be helpful, (i hate electrical:mad: )
 
Don't know if this will help but try hold the switch a little longer, then letting it go. My window will sometimes not come down if I just hit the switch, momentarily. :)
 
Fireman,



My guess is that it's in the switch. Seems I had mine out once for inspection - it pops out of the door panel fairly easily. You can unplug it and *carefully* pry the small clips on the white plastic cover away from the black housing. The circuit board comes out with the white plastic. You may be able to see any physical problems with it from there. There is a pin under the switch to engage the "one touch" feature, so I suspect that it uses the same wiring as if you were holding the switch in the down position. Good luck - oh, and welcome to the TDR! :D
 
Status
Not open for further replies.
Back
Top