Attention: TDR Forum Junkies 
Hey guys and gals,
I recently installed a fuel pressure gauge. Turns out I am running about 7psi at idle and about 1psi at WOT. So I have bought a Raptor 150 and a 2 micron filter set up from Glacier Diesel. Is there any input/tips that anyone could offer in regards to the installation of these components. Has anyone mounted the MK2 filter in the original lift pump location? We type of success have members had doing the new fuel in to the tank install, I was hoping to do it without lifting the bed or dropping the tank. If anyone has accomplished this and are there any tips you could offer.
Thanks everyone!
I recently installed a fuel pressure gauge. Turns out I am running about 7psi at idle and about 1psi at WOT. So I have bought a Raptor 150 and a 2 micron filter set up from Glacier Diesel. Is there any input/tips that anyone could offer in regards to the installation of these components. Has anyone mounted the MK2 filter in the original lift pump location? We type of success have members had doing the new fuel in to the tank install, I was hoping to do it without lifting the bed or dropping the tank. If anyone has accomplished this and are there any tips you could offer.
Thanks everyone!
Last edited:
