Rear hub torque specs needed!!

[Autobot]

I have an 06 3500 Mega Cab SRW and have pulled the rear axel and hub to replace a hub seal. Can any one help me out with the tourque specs for the spanner nut to reseat the bearings and the axel bolts?

 

[TCDiesel]

(1) Install outer hub bearing cup with Installer

8961 and Handle C-4171.

(2) Install inner hub bearing cup with Installer

8153 and Handle C-4171.

(3) Pack bearings with the appropriate wheel bearing

grease N/A

(4) Install rear bearing and install

seal with Installer 8963 and Handle C-4171.

(5) Slide hub on the axle tube and install front

bearing into the hub.

(6) Install hub bearing nut with Socket 8954 and

tighten to 30 N·m (22 ft. lbs. ) while rotating the hub



(7) Back off nut about 30° and align next hub nut

key slot with axle tube key slot and install locking

key.

NOTE: End play should be 0. 025-0. 25 mm

(0. 01-0. 001 in. )

(8) Install retainer ring with ring end in the key

slot.

(9) Install new axle shaft gasket and install the

axle shaft.