2nd Gen Non-Engine/Transmission Right turn steering

[bigbilldeucecoupe]

Bled brakes and made a couple of panic stops. Since then when making a sharp right turn it actually sticks and requires Me to manually pull it back. This only happens on a almost locked position right turn. It does have a steering stabilizer on it. Any help will be greatly appreciated. Thanks

 

[mweiman]

If a 4wd there is the possibility of a seized axle u-joint or the ball joints binding up. Did you do any other work besides bleeding the brakes?

 

[JMcCoy]

I would first loosen, or remove, the steering stabilizer bearing. and see if it persists. If it does, then start looking elsewhere. If it goes away, then I would check the steering stabilizer bearing and make sure it's properly adjusted. Good luck and keep us posted.