Recent Content by springer7711

LP pump just replaced my lift pump under warrenty, 33k miles on 2004. 5 these pumps should have been replaxced l0ong ago where is Iccoca when you need him??

how much did the adj. for the clutch cost??

bill I went with the FE from SBC , wish I had went with carolina or some one else, This FE is the grabber, rough , mean I hate it , cant back up without shaking the truck apart.

Did you use the stock rims, and did you raide the truck. I want to keep truck stock and not raiise it. I am thinking 37x12. 5x17. will it work???

I have a 2004-5 quad cab 2wd long bed . if I put 37x12x17 on , do I have to raise the truck? change the rims

I have installed the big filter my way. I removed all parts in front of the 90 degree elbow attached to the turbo , I mean everything , gives you some room. Next buy a 4inch abs black plastic coupling , drill a hole same dia as the inlet sensor, install the sensor. place coupling in elbow from...

I wiped out a two foot high fence,also wiped out the side of my 2004, 3500 slt brt white srw 4x2 long bed truck. If you know some one in northern ca. that has changed to a flat bed I am buying. I hear of many people that have take off beds but only when I dont need one. I hate two foot high...

I am thinking of getting a pac exhaust brake. Would like to hear from you folks , good and bad. $885. is not cheap for an old one like myself. thank you in advance. 04. 5 slt ho. srw 6speed, brt. white. 4x2 quad.

I just put an edge box on my truck, after reading about the need for guages, I installed boost, pyro. and have a fuel pres that is not hooked up yet. when I installed the boost guage I just cut the hose from the turbo to the bypass and spliced the elbow in. I get boost press. up to 40 psi...

Just hooked up a E_Z torque power module from ats, 545. 00 . It dont advance the time, it says in the adv. that it does. the fittings wouldnt fit at the turbo, I called them and he admitted that the ti ming did not change. just suckered out of 545$ . I am ******. 04. 5 slt lb lwb...

I called edge today and asked about their attitude box. It should be ready in approx 2months. I hope so my mph is putting me in the poor house 2. 29 per gal. Has anyone used the edge attitude box and is it what they claim? 04-5 HO 3500 slt srw antispin lb 6sp 4x2

better still , delete the 3rd injection alltogether, adjust timing.