Engine/Transmission (1998.5 - 2002) Need help with VP44 install

[wlowe]

I also posted this in the 911 forum. I need some help guys. I installed a VP44 today and while I was removing the rear most clamp down bracket for the High Pressure lines for cylinder 5 and 6 I dropped the clamp pieces. Now I'm not sure if I have all the parts.



This is the rear most clamp that attaches to a bracket for lines five and six. I have the two blue plastic pieces that go under/over the lines and I have the metal clip that goes on top of the upper blue plastic piece. What I'm not sure of is if there is a metal clip that goes under the lower blue plastic piece, or does the blue plastic piece just sit against the bracket.



If someone could take a look at their engine, or even take a picture and post it, I would greatly appreciate it.



Thanks

 

[BWagnaar]

I've changed injectors so many times I have a lost a couples of those blue pieces too. I just make sure mine dont rub on anything were its missing and RUN IT!

 

[wlowe]

I've changed injectors so many times I have a lost a couples of those blue pieces too. I just make sure mine dont rub on anything were its missing and RUN IT!

Yea, normally I wouldn't worry about it but I've read a few posts where injection lines have cracked because of the vibration caused from loose line clamps. I have both of the blue plastic pieces, I'm just not sure if there is a metal clip that goes under the lower blue plastic piece. If it does require that clip then the lines are going to be in a bind if I tighten the clamp down without the clip. Thanks for the response.

 

[JTroutman]

THe bottom blue piece just sits on the bracket that you bolt to

 

[wlowe]

THe bottom blue piece just sits on the bracket that you bolt to

Thanks for the info JTroutman, got everything installed and running today.