Perform Service message reset

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

How do you reset the TPMS on a 2017 3500 SRW ?

Failed Bearing Seals

Status
Not open for further replies.
The reason I asked was this thread I found. http://dodgeownerforums.com/smf/index.php?topic=18441.0

Which stated:

1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times within 10 seconds and hold it to the floor the second time.
4. Turn the ignition switch to the OFF/LOCK position and then let up on the accelerator pedal.​
Let me add to this, after turning the switch to ON, scroll to the stored message, then do step 2 and 3 and watch the message disappear before turning the switch off. Note: in step 2, 3 press and releases may be required.
 
Status
Not open for further replies.
Back
Top