Summit Exhaust Systems

[BFC]

Originally posted by shaft

Uhhhhhhh that was the point Glenn... ..... a reasonable source for the do it yourselfer... ... . be it 4 or 5 inch... ... . Since you seem to be searching for someone to argue with I believe I will let you have this thread though lol

No arguing here dude, I was just yanking your chain. Was all in fun!



Glenn

 

[ray1933]

Goof Ups

Originally posted by lschultz

Tank of diesel fuel too. Not gas.



I don't think the spell check will catch it if you put gas instead of diesel.



If you start talking about do do on here you will get Whitmore excited.

Guess it does not pay to post before one is fully awake.



Just back from town and filled up with DIESEL, over 22 miles per gal which is about 2 miles better than before.

 

[Hummin Cummins]

I'm with you, shaft

I love air flow systems. I have bought lots of stuff from them. I am also going to build a dual system. Probably 4" back through the splitter then 5" out. It doesnt seem to look that bad to do. I'm gonna dump them out at an angle right under the corners of the rear bumper



Chris

 

[shaft]

Thats the way I have my current 4" to 3" setup with a couple of 4" chrome tips... ...



There is some merit to using 4" back to two 5" if for no other reason than the cost of the 5" splitter

 

[Hummin Cummins]

Shaft

Do you have any pics of your setup? Do you tow? If so how much soot do you get on your trailer or the back of your truck. I have notice how in the rear it usually drafts up the tailgate



Chris

 

[shaft]

Re: Shaft

Originally posted by Hummin Cummins

Do you have any pics of your setup? Do you tow? If so how much soot do you get on your trailer or the back of your truck. I have notice how in the rear it usually drafts up the tailgate



Chris

Dont currently have any pics but I dont get any soot on truck or trailer... ... the pipes exit at about a 45 degree angle out the sides under the corner of the bumper... ... They actually stick out a bit so that the exhaust blows out to the side and back... ...



I do have a cam though... ... will see if I can take a couple pics tommorow and put them up... ... .

 

[bmoeller]

Originally posted by shaft

I found this site... ..... looks like they sell everything from straight pipe in 4" and 5" to the same in Y pipes, various bends, elbows etc... ...



Air Flow Systems



I have not actually sat down and figured it up yet but seems to me you could assemble your own 4 or 5 inch system for a reasonable price.



I am seriously thinking of creating a dual 5" system using the parts they have there to replace my current dual setup seen in sig line... ... .

Went on their site and under "Specialized Exhaust Systems", they have a complete 4" turbo-back system for the Dodge/Cummins and the Powerstoke. The Dodge system is $428. It's for the '94-02 trucks.