transmission question

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Ecm

Air Bag Light On - FIXED

Status
Not open for further replies.
I had my transmission rebuilt and am having a lot of problems with my tv cable. I took it back to the place that fixed it several times and they can't seem to dial it right in like it was before I rebuilt it. I was told that the computer has to learn the way I drive... is this true? And if it is how in the heck did it learn when I first purchased it and had never been in it? One thing was I thought I may be over analyzing it and that every little thing it is doing I am watching or feeling it and there may be nothing wrong. I was the one who ended up setting the cable after the fourth time from an archived thread and it was 100% better but when reading the instructions I just didn't understrand what WOT ment so I just set it did what ever not knowing what it ment. Can anyone give some ideas or what that means? Thanks!
 
The Throttle cable is very forgiving please describe exactly what the problem is,But this cable controls the line pressure. . if its not working properly (adjusted) it will destroy the trans in short order.
 
What kind of rebuild did you have done? A stock rebuild by a local transmission shop or a towing or performance rebuild done by a MOPAR automatic specialist with HD parts?

Does it hunt between 1st and 2nd gears at low speeds like with steady throttle around 20-25 mph?
 
It was a rebuild clutches, govt selenoids, etc. is all I know at a local shop. Just stockk know performance or towing. And it seems to be fine on what or when the shifts happen according to RPM, I just thought it was kinda hard shifting sometimes and then sometimes not. Thanks for the response by the way!!
 
@ HBarlow My truck seems to have that "slipping" problem at low speeds... I have an appointment to have it looked at on Monday, what kind of information can you give me on that problem before I go in? But my MPH are more around 15
 
@ HBarlow My truck seems to have that "slipping" problem at low speeds... I have an appointment to have it looked at on Monday, what kind of information can you give me on that problem before I go in? But my MPH are more around 15

I'm sorry, I am not a transmission expert and can't properly advise you. I know only general information about them.

Cerberusiam and a couple of others know transmissions and will hopefully see and respond to your post.
 
Status
Not open for further replies.
Back
Top