Truck starts up, but thats it

[johnnyboy_10138]

So, my battery had been dead for a while. I had a short with my remote battery jumping cables. So my batteries where completely dead



I got it jumped, it started up fine and I let it warm up. I put it in gear and nothing happened, When in idle i could get it to rev up a bit, but in gear no power unless i dropped it from neutral to gear, which i had to, to get it back in the parking spot.



So i turned it off and ran the codes, this is what I got on my BUlly dog.





p0602 ECM COM ERROR

P0113 Intake Sensor High

p2123 Pedal 1 high

1919

2121

3201

1321

2377



I cleared the codes, unistalled my bully dog, and got a few more codes, cleared those, and then it worked fine, drove around for like 30 minutes, made a stop, it started fine, no codes and then i parked it. That was on Thursday.



Today, I went to start it up. Noticed the check engine light was on. It sounded fine, but the pushing the pedal had no effect on revs, in idle, in gear, nothing. I was in a big rush, because I was in charge of hosting a party tonight, so i didnt pull codes. I can try to get those this week, but my truck is about 15 minutes from the baracks, and i am busy with class.



I have heard that sometimes the trucks dont like when you unistall The Bully Dog, and that reinstalling it could help.



I was running the Crazy larry program, but want to go back to stock program on the Bully dog, The CL has too much power.



Do you think I should go to the Dodge dealership and get them to flash the ecm, or try reinstalling the Bully Dog.



I could also sell the Bully Dog, and get something else for the truck.



What do yall think. I would like to have the truck for a road trip for next weekend. It is either fitting 5 rugby players in a Honda, or in the Dodge.

 

[JJPage]

But a new set of batteries, do not go to the dealer, and start over.



Here are what the codes mean;



https://www.turbodieselregister.com...s-diagnostic-trouble-codes-dtc-s-p-codes.html

 

[johnnyboy_10138]

I got a new set of batteries on Thursday.

 

[jelag]

The 04 is a fly by wire, no cable. .

 

[cerberusiam]

It sounds like your APPS may be the problem, pull the codes again and see what they say. No need to go to the dealer if you can pull the codes and do basic parts swapping. The Billy Dog seems to work well for some but it goes glitch on some trucks.



Get the problems solved whithout it loaded first then try loading it again.

The 04 is a fly by wire, no cable. .

Nope, MY 05 was the frist year of no cable. The MY 04 models all have a throttle cable and the APPS mounted under the hood, either on the front of the motor for the auto's or under the driver side battery for manuals.

 

[johnnyboy_10138]

Thanks guys, I will try to pull the codes this week, might not be until thursday.

 

[johnnyboy_10138]

I will check that out when I get to my truck.



i dont think it is a linkage issue. This happened when i got it started up orignally, but when i cleared the codes, it worked. I miss the truck

 

[TCDiesel]

Auto or Manual?

 

[jelag]

Woops... I now have to go out and look at our 04, I was sure it was fly by wire and not a throttle cable... . my mistake... . too many trucks. .

 

[johnnyboy_10138]

It is the auto.