My question is about APPS voltage. I have 2 sheets on APPS setup, one from Geno's and one from Blue Chip.
My voltage was at .67V, the high limit according to both setup sheets.
The difference between the two was that my Blue Chip sheet recommended backing (CCW to lower V) 1 turn and then (CW to raise V) until .6V is reached and then back off 1/2 turn. I couldn't get the voltage to go below .67V no matter how many turns I backed off.
Anyone have a similar situation? Any fixes to get the voltage to drop below the .67V high limit?
Thanks in advance
My voltage was at .67V, the high limit according to both setup sheets.
The difference between the two was that my Blue Chip sheet recommended backing (CCW to lower V) 1 turn and then (CW to raise V) until .6V is reached and then back off 1/2 turn. I couldn't get the voltage to go below .67V no matter how many turns I backed off.
Anyone have a similar situation? Any fixes to get the voltage to drop below the .67V high limit?
Thanks in advance