Here I am

DDIIIs and EZ...how hot?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Smart Controller

Help with price

Status
Not open for further replies.
I have been mulling over putting injectors in my truck for awhile now. I was set on DD2s for awhile and you know how that goes. So what would 3s be like? I run empty %90 of the time. I sometimes tow a open car trailer for a total of about 5K max behind my truck. But sometimes I use my dads trailer which puts me towing about 10K. So what kind if EGTs would I see possibly?? I want to do injectors not a fueling box also.



My truck has a K&N Re-0880 cone filter

Stock pipe with a straigh muffler(glasspak :rolleyes: )with no resinator.

And an EZ box



Not worried about the clutch either I already &^%$ it up



TIA Oo.
 
Clark,

Quit whining and get the PEC to go with 'em. . that way you can control the smoke a bit.

the DD3s on 1/1 are a blast and witha little restraint yield very little smoke.



The ez should be fine though. . put them on and don't worry about it. When you tow I'd make sure I set it on the lowest jumper and make sure you get an EGT guage.
 
Empty I have never seen over 1100° with DDIII's and the COMP in Level I, or with the COMP off its lower slightly. But I have a few more other things then you so take it for what its worth.



I have never towed anything so all I can give you is empty numbers,
 
Thanks Guys,



I do Have an EGT gauge pre turbo. I was able to touch 1300 pulling a 10K enclosed race trailer when it was 105* outside. I started from 0 and stayed WOT until 85 just to see how hot I could get it lol.
 
Status
Not open for further replies.
Back
Top