Attention: TDR Forum Junkies 
Got a bit of work done today.
I finished raking leaves/bagging them, worked on my trailer a bit, installed a thermostat in the house for one of the heaters, did some laundry, cut a shotgun barrel to send to my brother for machining, etc, etc... so I only had a couple hrs till I called it a day.
I got the baffles tacked in place after I cut the corners to 3" @ 45* and trimmed the long sides down a bit to fit correctly.
Also made a filler neck flange out of a floor flange I got at Home Depot and welding a piece of old driveshaft tubing to the bottom which will give me that 5% of headspace.
Tomorrow I'm gonna get some help putting the tank in the truck so I can mark where to put the drain. There's a hole from the factory in a nice spot, so I'm just going to enlarge it a bit.
I finished raking leaves/bagging them, worked on my trailer a bit, installed a thermostat in the house for one of the heaters, did some laundry, cut a shotgun barrel to send to my brother for machining, etc, etc... so I only had a couple hrs till I called it a day.
I got the baffles tacked in place after I cut the corners to 3" @ 45* and trimmed the long sides down a bit to fit correctly.
Also made a filler neck flange out of a floor flange I got at Home Depot and welding a piece of old driveshaft tubing to the bottom which will give me that 5% of headspace.
Tomorrow I'm gonna get some help putting the tank in the truck so I can mark where to put the drain. There's a hole from the factory in a nice spot, so I'm just going to enlarge it a bit.
