Ok, finished the installation and it appears to be working, have to road test after dinner. I am not sure what wiring harness they gave me.
1. One connector to control valve was wrong sex.
2. Orange wire that connects to White with Orange wire at PCM was 2 or 3 feet short.
3. Gray wire to coolant temp sender was 10" to short.
4. Blue wire to APPS was on the wrong side of firewall. Had to make up a wire run and buy plastic loom for that.
Did not use the T-taps, soldered all the connects.
The Larry-B heat shields works with a little trimming for the actuator rod and cylinder mounting plate.
On Edit, road test complete. Cruise control works fine etc etc. I can be on cruise control with Smart Controller and brake on (example 3rd gear) and speed up by foot throttle. When I let up the brake comes on unit I am back the pre-set speed, then it goes off and cruise control take over again. Have a little rattle or vibration when I true left at low speed, sounds like the turbo heat shield vibrating. Will have to check on that tomorrow. Does not seem to have picked up a drone or anything, but a good freeway run is needed you that and the freeway is 20 minutes away.
Tomorrow, have to remove the bolts for the brake one at a time and apply the anti-sez, one should really read the instruction first, right!
SNOKING l8r